Modify Selection
- Equipment, tools, and parts:
- Alarms
- or
- Backup alarms
- or
- CO alarms
- or
- Fire alarms
- or
- Methane alarms
- or
- Smoke alarms
Home Links
Results 1 - 10 of 18
-
11/1/2008 - Information CircularsThe results of NIOSH's test of two commercially available proximity warning devices (PWDs) are presented. PWDs warn personnel if mobile equipment moves within some preselected minimum distance of an energized overhead electrical power line.
-
9/1/2008 - Conference papersThis paper summarizes recent accomplishments in a research program that is addressing mine fire prevention, detection, management, and suppression, and provides an overview of the next phase of the NIOSH mine fire research program.
-
5/1/1997 - Technology NewsThe new permissible-type, intrinsically safe design modules described here represent an engineering intervention strategy toward improving miners' ability to recognize and avoid the hazardous zone of unsupported mine roof.
-
1/1/1991 - Reports of InvestigationsThis report details the results of a series of large-scale experiments where small coal fires were used to ignite the conveyor belt at specific air velocities, and showed conditions required for early detection of conveyor belt entry fires.
-
3/1/2015 - Peer reviewed journal articlesAn article detailing experiments conducted to evaluate the response characteristics of commercially available gas, smoke and flame sensors to fires of common combustible mine materials.
-
9/28/2012 - News articlesNIOSH is developing a prototype intelligent system that provides enhanced protection by continuously monitoring miners’ positions in relation to the machine and established safety zones.
-
4/1/2010 - Peer reviewed journal articlesThis paper discusses large-scale experiments conducted by NIOSH to evaluate the effectiveness of optical flame detectors, photoelectric smoke detectors, and combined ionization/photoelectric smoke detectors for detecting mining equipment cab fires.
-
12/1/2008 - Peer reviewed journal articlesThis paper describes the in-mine evaluation of a smart mine fire sensor system and discusses recommendations for improving the system.
-
6/1/2006 - Conference papersFive mine fire experiments were conducted in a 2.08-m-high, 2.90-m-wide ventilated mine entry in NIOSH's Safety Research Coal Mine to determine the effect of the dispersion of carbon monoxide (CO) on mine fire detection.
-
1/1/2005 - Conference papersThis paper describes test procedures used to evaluate performance of methane monitors that could be used underground for continuous personal monitoring of methane. The information in this report provides data that allow the reader to make side-by side c...
Home Links
Content source: National Institute for Occupational Safety and Health, Mining Program