Modify Selection
- Hazards and exposures:
- Noise
- Document types:
- Peer reviewed journal articles
Home Links
Results 21 - 28 of 28
-
1/1/2007 - Peer reviewed journal articlesNoise surveys were conducted in eight coal preparation plants. Results indicate that only workers who routinely spend a significant portion of their shift in the plants (away from the control rooms) are susceptible to overexposure from noise.
-
1/1/2007 - Peer reviewed journal articlesThis study examines the patterns and trends in noise exposure documented in data collected by Mine Safety and Health Administration inspectors at U.S. coal mines from 1987 through 2004.
-
11/1/2006 - Peer reviewed journal articlesThis report summarizes the results of noise surveys, consisting of full-shift worker noise exposure, time-motion studies, and equipment noise profiling for longwall and continuous miner sections in six underground coal mines.
-
10/1/2006 - Peer reviewed journal articlesThis article describes noise research conducted in limestone mines, detailing the equipment likely to cause worker overexposures, the occupations experiencing overexposures, and the implications for worker noise exposure reduction.
-
1/1/2006 - Peer reviewed journal articlesNIOSH initiated a study of a roof bolter to reduce noise exposure to mine roof bolter operators. When drilling into granite, it was found that wet drilling generated lower sound power levels and performed better than vacuum drilling.
-
12/1/2005 - Peer reviewed journal articlesThis study outlines potential challenges regarding job safety and hearing conservation practices for noise-exposed, hearing-impaired workers.
-
12/1/2005 - Peer reviewed journal articlesThis publication describes worker noise exposure surveys in coal mines and coal preparation plants, revealing that worker dosimetry, time-motion studies, and equipment noise profiling are important for effective use of administrative controls.
-
1/1/2005 - Peer reviewed journal articlesThis paper reports on a cooperative study on vibrating screen noise conducted at a coal preparation plant. Rubber isolators were found to reduce sound levels by 1 dB and amped side plates reduced vibration levels on the screen sides by 1 to 7 dB(A).
Home Links
Content source: National Institute for Occupational Safety and Health, Mining Program