- Equipment, tools, and parts
- Geographic regions
- Geologic conditions and events
- Hazard prevention and control
- Hazards and exposures
- Mine locations, excavations, and structures
- Mining types and methods
- Population groups
- Products and materials
- Research disciplines
- Research methods and measures
- Tasks and activities
- Document types
Results 11 - 20 of 85
1/1/1994 - Reports of InvestigationsProduction trends were analyzed for 82 gob gas ventholes on 7 longwall panels in the Lower Kittanning Coalbed, Pennsylvania.
1/1/1993 - Reports of InvestigationsCatalyzed diesel particulate filters (CDPFs) reduce the concentration of diesel particulate matter (DPM) and may reduce the emissions of carbon monoxide (CO) and hydrocarbons (HC) in diesel exhaust.
1/1/1992 - Reports of InvestigationsThe U.S. Bureau of Mines has developed an intrinsically safe carbon monoxide (CO) monitoring system for mines by coupling a fiber-optic data telemetry system with a prototype electrochemical CO monitor.
1/1/1989 - Reports of InvestigationsThe U.S. Bureau of Mines used a contact drilling strategy with short-collared assemblies in order to rotary drill long horizontal methane drainage holes in the Beckley coalbed near Glen Daniel, West Virginia. By decreasing the thrust and increasing the ...
The Bureau of Mines conducted an investigation into the occurrence of outbursts of salt known to be responsible for explosions, fatalities, and damage in domal salt mines. The purpose of the investigation was to develop a basis for predicting these outb...
The Bureau of Mines has developed a system using a high-speed electropneumatic mechanism for the rapid (grab) sampling of dusts and gases during an explosion to monitor pyrolysis-charring in coal particles and combustion of pyrolysis vapors.
A Bureau of Mines geologic study of Pennsylvanian and Permian coalbeds in southwestern Pennsylvania was undertaken to determine the effects of coalbed geology and petrology on in situ coalbed gas contents.
The Bureau of Mines has developed a practical methodology for determining occluded gas contents of domal rock salt samples. The method, which is portable and fieldworthy, provides results in 5 min or less.
Gob holes are routinely used by the mining industry to vent methane from gobs and to prevent it from entering the mine ventilation system. In some cases, flows from gob holes are measured by centering an anemometer on the end of a discharge pipe. These ...
The Bureau of Mines determined the gas contents of 135 oil shale samples obtained from approximately 630 ft of core drilling. Drilling was done within a projected mining zone of the Cathedral Bluffs Mine, located in the Piceance basin of western Colorad...