Modify Selection
- Hazards and exposures:
- Accidents and emergencies
- or
- Electrical accidents
- or
- Explosions
- or
- Bursts
- or
- Ignitions
- or
- Storms (electrical)
- or
- Fires
- or
- Spontaneous combustion
- or
- Entrapment
- or
- Flyrock
- or
- Avalanches
- or
- Inundations
- or
- Emergencies
- or
- Disasters
- or
- Ground falls
- or
- Roof falls
- or
- Rib falls
- or
- Rib sloughage
- or
- Highwall falls
- or
- Falling objects
- or
- Equipment accidents
- or
- Loss of vehicle control
- or
- HAZMAT transport accidents
- or
- Rollovers
- or
- Collisions
- or
- Falls
- or
- Falls from heights
- or
- Slips and trips
- or
- Bumps
Home Links
Results 71 - 80 of 504
-
8/1/2003 - Peer reviewed journal articlesLaser-based instruments are used in areas where coal dust ignition presents a safety hazard. This NIOSH study determines when an optical beam may be considered a potential ignition source in underground coal mines or coal storage facilities.
-
2/1/2003 - Reports of InvestigationsNIOSH is evaluating methods to decrease accidents including one that uses devices that assist equipment operators in monitoring blind areas around the equipment to prevent collisions with workers on foot or other objects.
-
12/1/2001 - Conference papersTechnology and realistic training simulations have been identified for the general workforce and mine emergency responders. Laser lights and lifelines were beneficial in leading personnel to safety and out of the mine in smoke-filled passageways.
-
8/1/2001 - Conference papersThis paper introduces warning signs of slope instability so operators are better able to recognize hazards. The most common slope monitoring equipment and practical methods of installation are discussed as well as the limitations of these systems.
-
8/1/2001 - Conference papersA statistical study of roof bolt performance was conducted in 37 U.S. mines. Analysis of the results led to guidelines for making preliminary estimates for bolt length, capacity, and pattern to improve roof stability in difficult conditions.
-
8/1/2001 - Conference papersThis paper discusses misconceptions about how roof supports perform and factors that impact their performance. The paper is limited to a discussion of secondary roof support systems and powered roof supports such as longwall shields.
-
8/1/2001 - Conference papersFire is a major concern for those who work in underground mines. This paper focuses on responders' preparedness for fire.
-
2/1/2001 - Conference papersEvaluation of the "Advance and Relieve" mining method is described to determine effectiveness for conditions where high horizontal stresses caused long running roof falls resulting in hazardous conditions and the premature abandonment of panels.
-
10/1/2000 - Information CircularsThe proceedings provide information on several new technologies including guidelines for roof bolt length, pattern, and capacity; a new design method for longwall tailgate supports; and a technique for measuring loads developed within cable bolts.
-
9/1/2000 - Conference papersThis paper describes technology and training that has been identified for underground emergency responders.
Home Links
Content source: National Institute for Occupational Safety and Health, Mining Program