• Component Description
• Eligible Sample
• Description of Laboratory Methodology
• Data Processing and Editing
• Laboratory Quality Assurance and Monitoring
• Analytic Notes
• References
• Codebook
  • SEQN - Respondent sequence number
  • URXUIO - Iodine, urine (ug/L)
  • URXUCR - Creatinine, urine (mg/dL)
  • WTSA2YR - Environmental A 2 year weights

National Health and Nutrition Examination Survey

2009-2010 Data Documentation, Codebook, and Frequencies

Iodine - Urine (UIO_F)

Data File: UIO_F.xpt

First Published: September 2011

Last Revised: NA

Component Description

Iodine, an essential element for thyroid function, is necessary for normal growth, development, and functioning of the brain and body. Iodine-deficiency disorder (IDD) is a well documented global health problem, affecting more than a billion people worldwide. Consequences of IDD include goiter, cretinism, intellectual impairment, brain damage, mental retardation, stillbirth, congenital deformities, and increased perinatal mortality. Progress toward eliminating IDDs has been substantial; an estimated 70% of the world’s edible salt currently is iodized. Most excess iodine is excreted, and most people can tolerate fairly large amounts without experiencing problems. People with a tendency toward autoimmune thyroid disease are less tolerant of excess iodine. If a person has previously been iodine-deficient, that person may be at risk for iodine-induced hyperthyroidism. Excessive iodine intake by a mother can pose a reproductive risk. Since urinary iodine values directly reflect dietary iodine intake, urinary iodine analysis is the recommended and most common method for biochemically assessing the iodine status of a population. This method achieves rapid and accurate quantification of iodine content in urine.

Eligible Sample

Participants aged 6 years and older, who met the subsample requirements, were eligible. For 2007-2008, testing was performed on all survey participants, but for 2009-2010, the testing was performed on a one-third subsample.

 

Description of Laboratory Methodology

Urine specimens were processed, stored and shipped to Division of Laboratory Sciences, National Center for Environmental Health.

Urine iodine concentrations are determined by ICP-DRC-MS (Inductively Coupled Plasma Dynamic Reaction Cell Mass Spectroscopy). This multielement analytical technique is based on quadrupole ICP-MS technology and includes DRC™ technology. Coupling radio frequency power into a flowing argon stream seeded with electrons creates the plasma, the heat source, which is ionized gas suspended in a magnetic field. Predominant species in the plasma are positive argon ions and electrons. Diluted urine samples are converted into an aerosol using a nebulizer inserted within the spray chamber. A portion of the aerosol is transported through the spray chamber and then through the central channel of the plasma, where it is exposed to temperatures of 6000-8000 ºK. This thermal energy atomizes and ionizes the sample. The ions and the argon enter the mass spectrometer through an interface that separates the ICP, which is operating at atmospheric pressure (approximately 760 torr), from the mass spectrometer, which is operating at approximately 10^-5 torr. The mass spectrometer permits detection of ions at each mass-to-charge ratio in rapid sequence, which allows the determination of individual isotopes of an element. Once inside the mass spectrometer, the ions pass through the ion optics, then through DRC™, and finally through the mass-analyzing quadrupole, before being detected as they strike the surface of the detector. The ion optics uses an electrical field to focus the ion beam into the DRC™. The DRC™ component is pressurized with an appropriate reaction gas and contains a quadrupole. Electrical signals resulting from the detection of the ions are processed into digital information that is used to indicate the intensity of the ions and subsequently the concentration of the element. Traditionally ICP-MS has been a trace analysis technique and the typical measurement ranges from < 0.1 µg/L to around 100 µg/L. DRC technology provides additional control of ICP-MS sensitivity; therefore appropriate adjustments of the reaction cell parameters can significantly extend the useful concentration measurement range. In this method, iodine (isotope mass 127), tellurium (isotope mass 130), mercury (isotope mass 202) and bismuth (isotope mass 209) are measured in urine by ICP-DRC-MS using 100% argon as the Dynamic Reaction Cell™ (DRC) gas utilizing collisional focusing. Urine samples are diluted 1+1+ 8 (sample+ water + diluent) with water and diluent containing tellurium and bismuth for internal standardization

There were no changes (from the previous 2 years of NHANES) to equipment, lab methods, or lab site.

Detailed instructions on specimen collection and processing can be found in the NHANES Laboratory/Medical Technologists Procedures Manual (LPM).

Data Processing and Editing

Read the General Documentation on Laboratory Data file for detailed data processing and editing protocols. The analytical methods are described in the Description of Laboratory Methodology section above.

Laboratory Quality Assurance and Monitoring

The NHANES quality control and quality assurance protocols (QA/QC) meet the 1988 Clinical Laboratory Improvement Amendments mandates. Detailed QA/QC instructions are discussed in the NHANES Laboratory/Medical Technologists Procedures Manual (LPM). Read the General Documentation on Laboratory Data file for detailed QA/QC protocols.

 

Analytic Notes

NHANES Survey Design:
The analysis of NHANES laboratory data must be conducted with the key survey design and basic demographic variables. The Demographic file contains: Status Variables providing core information on the survey participant including examination status, Recoded Demographic Variables including age, gender, race etc., and Interview and Examination Sample Weight Variables and Survey Design Variables. The Questionnaire Data Files contain socio-economic data, health indicators, and other related information collected during household interviews. The Phlebotomy Examination file includes auxiliary information on duration of fasting, the time of day of the venipuncture, and the conditions precluding venipuncture. The Demographic, Questionnaire and Phlebotomy Examination files may be linked to the laboratory data file using the unique survey participant identifier SEQN.

For 2007-2008, testing was performed on all survey participants, but for 2009-2010, the testing was performed on a one-third subsample.

Subsample weights
Measures of urinary iodine were measured in a one third subsample of persons 6 years and over. Special sample weights are required to analyze these data properly. Specific sample weights for this subsample are included in this data file and should be used when analyzing these data.

Variance estimation
The analysis of NHANES laboratory data must be conducted with the key survey design and basic demographic variables. The NHANES Demographic Data File contains demographic and sample design variables. The recommended procedure for variance estimation requires use of stratum and PSU variables (SDMVSTRA and SDMVPSU, respectively) in the demographic data file.

Links to NHANES

This laboratory data file can be linked to the other NHANES data files using the unique survey participant identifier SEQN.

Please refer to the NHANES Analytic Guidelines and the on-line NHANES Tutorial  for further details on the use of sample weights and other analytic issues.

References

• Tanner SD, Baranov VI, Bandura DR, Reaction cells and collision cells for ICP-MS: a tutorial review. Spectrochimica Acta part B 57, 2002: 1361-1452.
• Tanner SD, Baranov VI., Theory, design and operation of a DRC™ for ICP-MS. Atomic Spectroscopy 1999; 20(2): 45-52.
• Thomas R, Guide to ICP-MS. New York: Marcel Dekker; 2004.

Codebook and Frequencies